How to make a Patch lead
 |
|
 |
|
||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
1) Skin off the cable jacket approximately 1" or slightly more. 2) Un-twist each pair, and straighten each wire between the fingers. 3) Place the wires in the order of one of the two diagrams shown above (568B or 568A). Bring all of the wires together, until they touch. 4) At this point, recheck the wiring sequence with the diagram. 5) Optional: Make a mark on the wires at 1/2" from the end of the cable jacket. |
8) Insert the wires into the connector (pins facing up). | |
 |
6)
Hold the grouped (and sorted) wires
together tightly, between the thumb, and
the forefinger.
7) Cut all of the wires at a perfect 90 degree angle from the cable at 1/2" from the end of the cable jacket. This is a very critical step. If the wires are not cut straight, they may not all make contact. We suggest using a pair of scissors for this purpose. |
9) Push moderately hard to assure that all of the wires have reached the end of the connector. Be sure that the cable jacket goes into the back of the connector by about 3/16". |
 |
 |
7B) Conductors should be at a straight 90 degree angle, and be 1/2" long, prior to insertion into the connector. | 9) Place the connector into a crimp tool, and squeeze hard so that the handle reaches it's full swing. |
 |
RADVISION - SCOPIA Elite 5000 MCU
With 1080p High Definition
processing, multistream telepresence connectivity,
unlimited conferences, personal video layout per
participant and AAC audio, SCOPIA Elite delivers
supreme High Definition conferencing. Utilization of
the very latest state of the art DSP technology
offers uncompromised HD.